EemaX EMT6 Instruction Manual download pdf (Page 7)

TECHNICAL DESCRIPTION

There are four Eemax Mini tank models, a 1.3 gallon, a 2.5 gallon, a 4

gallon and a 6 gallon model. The pressure vessel (water tank) is welded,

glass lined steel and is equipped with an anode rod.

The water heater is equipped with a thermostat and a high limit

temperature switch. A temperature/pressure relief valve is supplied with

the unit.

INSTALLATION INSTRUCTIONS

EMT1 - EMT2.5 - EMT4 - EMT6

The installation must be completed by a licensed professional. All state

and local codes must be adhered to. The manufacturer will not be liable

for any damages because of failure to comply with these installation

instructions or because of improper installation performed by an

unqualied installer.

CHOOSE A LOCATION that allows ease of access for maintenance or

servicing, ideally installed at least 8” to 9” from the ceiling (inside top of

cabinet) or any adjacent walls.

WALL MOUNTING

Fasten the supplied mounting bracket to the wall. Use screws that are

suitable for the wall material and the weight of the water heater lled to

capacity (EMT1 = 24 lbs. - EMT2.5 = 41 lbs. - EMT4 = 57 lbs. - EMT6 =

76 lbs.). Hang the water heater on the bracket and pull downwards on

the water heater to insure that both “ngers” of the bracket are seated in

the mounting slots. Conrm your water piping orientation (hot and cold)

before wall mounting. ONLY INSTALL IN VERTICAL POSITION.

Heater can sit on the oor. Conrm water piping orientation before

nalizing on oor. ONLY INSTALL IN VERTICAL POSITION!

EMT models can be installed under the sink.

Page 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

EemaX EMT6 Instruction Manual Page 7