EemaX EMT4 Instruction Manual download pdf (Page 11)

ELECTRICAL CONNECTIONS

To be certain that all of the air is out of the water heater, open the HOT

water faucet on your xtures until constant water ows from them. If air

remains in the tank, the element will be damaged when the electric cord

is plugged in.

Connect the water heater to a GROUNDED OUTLET.

The water heater is tted with a power cord that is intended to

plug into a grounded 110-120 V/AC receptacle. Adhere to all

pertinent State and local codes. Install the correct size circuit

breaker into the master panel. The Eemax EMT water heater was

manufactured and wired in accordance with UL requirements.

The water heater is equipped with an overheat limiting device

with a manual reset. Also known as the temperature high limit,

this device has been factory installed to interrupt the power sup-

ply in the event of a thermostat failure.

This water heater is designed for ONLY 110-120V electrical

service!!!!! DO NOT CONNECT TO HIGHER OR LOWER VOLTAGE.

Failure to use proper voltage may result in personal injury and/or prop-

erty damage. If the supplied electrical power cord is either damaged or

not long enough, do NOT use an extension cord. Have a licensed electri-

cian replace the power cord.

Page 10

Eemax mini tank manual.indd 11 5/30/2008 10:44:51 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

No comments

EemaX EMT4 Instruction Manual Page 11